![]() If you are unsure how to tell the speed limit on UK roads then read our helpful blog. It is vital that you do not exceed the speed limit during your driving test. Try to be cautious though, you don’t want to approach an amber light at speed getting caught out if it turns to red. Traffic lights are usually straightforward. The driving theory test should ensure that you have good knowledge of UK road signs and traffic lights, and how to react to them. You are also expected to follow and respond to traffic lights. Response to Signs: Road Markings & Traffic Lightsĭuring your driving test, you will be expected to check for and read the road markings and traffic signs and then act accordingly. The examiner will be checking to see that you are positioning the car appropriately on the road as you are driving. When driving on roads with multiple lanes you need to determine which lane to take and how best to position the car. Failures for control include rolling backwards, stalling the engine and moving away at too high a speed.Īs you drive along the road you need to consistently adjust the positioning of your car in relation to the side and the centre of the road, ensuring that you stay within the lines of a marked lane. The examiners will request that you park the car up on the left side of the road and when ready, move off again.įailures for safety include no attempt to look around, a lack of observation and moving away when unsafe. You may also, where possible, be required to perform the manoeuvre on an uphill gradient. ![]() However, you will fail the driving test if the examiner doesn’t think that you’re in control of your steering.Īs part of the driving test, you will be required to move away on a flat surface, from behind a stationary vehicle. Most people believe you will fail your driving test for crossing your hands on the steering wheel, this isn’t true. As part of the UK driving test the driving examiner will check that your steering is smooth and safe. It is important to maintain a high level of control when steering. If you are driving with no turns or junctions ahead you still need to check your mirrors every few seconds. From the very beginning, a learner driver should be taught about the blind spots and where to look before pulling away from the side of the road.Īlways use your mirrors before any change of direction including turning, overtaking and changing lanes. Observing and using your mirrors is something most people normally do not do anywhere near enough. At many fast road or junctions with very poor vision, you will find a “STOP” sign and you must in law completely stop at this junction. When dealing with junctions you must always consider whether it is safe to pull out and if you have enough time to get you and going before another vehicle comes along.Īt APass4U we’ve written a lot about junctions, including open and closed junctions and box junctions. The top reasons for failing the driving test between 20 are:įailing to look properly at junctions is the most common dangerous test fault and the largest cause of accidents in Britain. In 2017, the most common contributory factor in accidents was drivers failing to look properly. The faults being made in driving tests reflect the factors that cause accidents on Great Britain’s roads. ![]() ![]() Learner drivers need to prepare for a lifetime of safe driving, not learn just enough to pass a driving test. They need the skills to drive on all types of roads before taking a driving test. It is of vital importance that learner drivers can drive safely. The Driver and Vehicle Standards Agency (DVSA) has revealed the top reasons that people failed the driving test in the last year. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |